Installing Those Christmas Lights
Almost any person could get easily anxious of the fact that it is both the holidays and that, they are putting some Christmas lights into their home. It is unfortunate though to think that not every single person prioritizes this task first in their Christmas bucket list. This is actually quite sad for anyone in the holiday spirit to comprehend. You should not treat the installation of those lights as a burden. This is one lucky day for you, as this read would give you the much needed advice in order to give the holidays the best atmosphere. You really do not have to worry too much as everything that is mentioned is coming from a light installation professional.
First and foremost, if you are up to staple those lights in your home, then go instead for the wire tacker than an average stapler. Those average ones could potentially damage the protective coating. You may face some short circuiting problems if you have managed to damage those wires in the first place. You should know that the staples used in a wire tacker are u-shaped and that they only leave some small space for the cable wire to move around. This is to make sure that the wires stays in pristine condition. What is advised for you to do is to staple one inch of the wire from the different sides of the light. This is to make sure that the lights would stand and look consistent from the outside. You are assured to have some neat looking finish with that facade and aesthetic you are going for.
Provide a reasonable distance for those lights of yours around the perimeter of your home or building. This provides you a neater overall finish.
Non-invasive clips may be good for you to utilize if you do not want to have some prevalent staple marks showing. These things are rather cheap for you buy, and you could easily install them around the premise of your home. Though, you have to consider one for every single light bulb.
As much as possible, do not hang those lights facing upward or even staple them for that matter. You may face some shortage problems once water would get in. A good advice for you to keep in mind is to have them point down or out the premise.
To be sure of potential malfunctioning, use an electrical tape to seal both end plugs between strands. Again, water may be a strong culprit for such lights to go off, which could ruin your holiday spirit and cheer in the process.
If these things are too much for you, then opt for a professional installer that could help you out. In this way, you could get the best of your investment in the long run.